濾波器
電感成型之粉末成型機
 

　　本機台是電感成型之粉末成型機，採高熵合金模具材質製作，搭配全伺服馬達，高穩定高速生產，可配合自動化大幅提升產量，及採全伺服精密高科技人機介面觸控，操作簡單方便，本機體機最大特點機台小型化可攜帶式，攜帶搬遷容易。
<=左為機器運作模擬影片
下方為研究報告<請按此點閱或按右鍵另存新檔>
 

濾波器

 
 
GENERAL MATERIAL PROPERTIES
Material
Reference
Relative
Color
Mix No.
Permeability(μ°)
Cost
Code
-2
10
5.0
Red/Clear
-8
35
5.5
Yellow/Red
-18
55
2.7
Green/Red
-26
75
1.0
Yellow/White
-28
22
2.4
Gray/Green
-33
33
2.2
Gray/Yellow
-38
85
1.3
Gray/Black
-40
60
1.0
Green/Yellow
-45
100
3.0
Black/Black
-52
75
1.3
Green/Blue

MATERIAL APPLICATIONS
Typical Application
-2
-8
-18
-26
-28
-33
-38
-40
-45
-52
Light Dimmer Chokes
X
X
X
X
60Hz Differential-mode EMI Line Chokes
X
X
X
X
X
DC Chokes:<50KHz or low Et/N
X
X
X
X
X
X
DC Chokes:>=50KHz or higher Et/N
X
X
X
Powder Factor Correction Chokes:<50KHz
X
X
X
X
Powder Factor Correction Chokes: >=50KHz
X
X
X
X
Resonant Inductors: >=50KHz
X

MATERIAL DESCRIPTION
-2 Material -33 Material

 The low permeability of this material will result in lower operating AC flux density than with other materials with no additional gap-loss.

 

 An inexpensive alternate to the -8 Material for applications where high frequency core loss is not critical. Good linearity with high bias.

 
-8 Material -38 Material

 This material has low core loss and good linearity under high bias conditions. A good high frequency material. The highest cost material.

 

 A higher permeability alternate to -26 Material. A low cost material best used at line frequency.

 
-18 Material -40 Material

 This material has low core loss similar to the -8 Material with higher permeability and a lower cost. Good DC saturation characteristics.

 

 The least expensive material. It has characteristics quite similar to the very popular -26 Material. Popular in large sizes.

 
-26 Material -45 Material

 The most popular material. It is a cost-effective general purpose material that is useful in a wide variety of power conversion and line filter applications.

 

 The highest permeability material. A high permeability alternate to -52 Material with slightly higher core losses.

 
-28 Material -52 Material

 The good linearity, low cost, and relatively low permeability of this material make it popular in large sizes for high power UPS chokes.

 

 This material has lower core loss at high frequency and the same permeability as the -26 Material. It is very popular for high frequency choke designs.

 

NOTE: For information an Mix #'S 6 and 10 please contact with our sales department.

 

E-mail to Bewise
Copyright (c) 2003 by Bewise Inc.